Model:
SWRO-200
200-300 GPD/ 757-1135 LPD
Seawater
Reverse Osmosis Desalination System (Watermaker)
Daily production
rate: 200-300 GPD/ 757-1135 LPD
Feed water: less
than 38000 ppm
Required feed water
pressure: 40 psi
Average feed water
temperature: 25 °C/ 77 °F (output is rated at this feed water temperature)
Product water
quality: less than 500 ppm
Recovery Rate: 10%
Feed water rate: 1.5 GPM
Working Pressure: up to 950
psi
Dimension (L x W x
H): 122 x 51 x 45.7 (cm)/ 48 x 20 x 18 (in)
Shipping Weight: 190
lb/ 86 kg (including crate)
RO System
The construction of the membrane is a
Thin Film Composite (TFC). It is the highest quality membrane
available in the industry. The reverse osmosis pressure vessel is a
heavy-duty housing made of corrosion resistant fiberglass.
Pre-Filtration System: PVC
housing, 5-micron cartridge type sediment filter further reduces
suspended solids in the feed water stream to RO system. It protects
the RO high-pressure pump and lead end RO membrane elements from
debris. 5
GPM rating. 1
No.
Membrane
Housing:
fiberglass, 2.5"
housing, holds 1
membrane, 1000
psi rated pressure vessel, 1
No.
Membranes:
1 No.
2.5"x40"
High
pressure RO Pump: CAT Pump, 316 SS
Motor
(120VAC/60hz/single
phase): 3/4 HP, TEFC.
High
pressure side piping material:
316L Stainless Steel
Low
pressure side piping material:
Schedule 80 PVC
Concentrate
control valve:
316 Stainless Steel
Water
quality monitor:
product water TDS meter
Flow
meters:
Panel Mount Flow Meters
for feed water and product water.
Pressure
Gauges:
Feed Water Pressure,
working pressure, Concentrate
System
controls (automatic
operation ):
Automatic control to
provide start/stop, sequential, and alarm control.
RO
System start permissible conditions:
Power On
Start
button pushed
No Low
pressure Fault
Permeate
water tank level below low level (low and high level switches are on
open
position)
Five conditions will cause the RO to shut down
the machine:
Low
inlet pressure (<20 psi)
Fuse overload
Product
water storage tank level high
Stop button pushed.