Feed water: less than 38,000 ppm
Required feed water pressure: 40 psi
Average feed water temperature: 25 °C/ 77 °F
Product water quality: less than 500 ppm
Feed water rate: 1.8 GPM
Working Pressure: 900 psi
Dimension (L x W x H): 114 x 41 x 45.7 (cm)/ 45 x 16 x 18 (in)
Weight: 85 lb/ 39 kg
Power consumption: 0.82KW at 900 psi (excludes feed water pump)

The construction of the membrane is a Thin Film Composite (TFC). It is the ones of the highest quality membranes available in the industry. The reverse osmosis pressure vessel is a heavy-duty housing made of corrosion resistant fiberglass.

• Pre-Filtration System: PVC housing, 5-micron cartridge type sediment filter further reduces suspended solids in the feed water stream to RO system. It protects the RO high-pressure pump and lead end RO membrane elements from debris. 5 GPM rating. 1 No.

• Membrane Housing: fiberglass, 2.5" housing, holds 1 membrane, 1000 psi rated pressure vessel, 2 No.

• Membranes: ForeverPure seawater desalination membrane , 2 No. 2.5"x40"

• High pressure RO Pump: 316 Stainless Steel.

• Motor (120VAC/60hz/single phase or 220VAC/50hz/single): CAT, 1.5 HP, TEFC.

• High pressure side piping material: 316 Stainless Steel

• Low pressure side piping material: Schedule 80 PVC

• Concentrate control valve: 316 Stainless Steel

• Water quality monitor: product water TDS meter

• Flow meters: Panel Mount Flow Meters for feed water and product water.

• Pressure Gauges: Feed Water Pressure, working pressure, Concentrate

• System controls (automatic operation):

Microprocessor control to provide start/stop, sequential, and alarm control.

RO System start permissible conditions:

1. Power On

2. Start button pushed

3. Low pressure switch closed

4. Permeate water tank level below low level (low and high level switches are on open position)

1. High working pressure,

2. Low inlet pressure (<15 psi)

3. over current

4. Product water storage tank level high

5. Shut-down button pushed.

A multimedia filter is designed to make better use if the bed depth in the removal of a greater volume of suspended solids. This is achieved by loading larger media granules of lower density at the top of the bed, with at least one layer of smaller media granules of higher density below it. The larger granules remove the larger suspended particles, leaving the smaller particles to be filtered by the finer media. Three depth multi-media filtration system is used to filter sand and sediment (turbidity) down to approximately 20 Microns. Manual backwash when clogged. Saves replacement filter cost. Filter size is 8"x 18" , with high performance mineral polyglass tank. 1 .No.

Feed water pump deliver water from the ocean or a raw water storage tank to the desalination system (watermaker). Due to many different variation in feed water intake setup, please provide installation details to ForeverPure in order to get the correctly sized intake pump.

• Inverter+ AC Charger + Solar Charger 3-in-1 design

• Built-in MPPT 60A solar charger

• Max AC charging up to 60A (48v models only)

• Max total system charging (solar charging + AC charging): 60A + 60A = 120A !!

• High frequency, light-weight design

• Highly programmable menu

• Wide AC input range

• Adjustable Bulk/Float Voltage

• Supports various lead acid batteries, LiFePo4

• Pure sine wave output

• 2X surge capacity up to 5 seconds

• USB communication

• LCD monitor display system info + LED indicators

• FREE monitoring software included

• Built-in generator starter dry contact -- inverter generator is highly recommended

• Overload/Over-temperature/short circuit protections

• Cold start capability (requires DC)

Electrical Specifications